HOW SETTING WIRELESS BULLET

discuss how to apply the settings Bullet 2HP as BTS transmitter that can be received directly by the user's laptop (Access Point) and at the same time using one of the first experience Ubiquiti products.

Following the steps of his setting:

After all devices have been correct installation, connect the UTP cable to the computer via POE mate with a straight connection type and then note the IP address bullet which by default is 192.168.1.20, then set the IP for example 192.168.1.21 pal Lan computer then input the same as the Default Gateway IP Bulletnya .



Next please buddy, open your browser and then fill in the address bar 192.168.1.20, so if the correct setting will appear AirOS bulletnya early, so my friend can see on the Main tab there is information about setting the default bullet.
  1. To start setting the bullet as a transmitter, and then select the tab and set the Wireless Link Setup Mode on Point or WDS Accsess it, if my friend wanted the bullet as a receiver in this case acts as a client then select Station. Transmitter is loaded SSID name pal. Because the bullet I want to make as a transmitter that can be received directly by the user's laptop then on my chosen mode of IEEE 802.11 B / G Mixed, then to Channel Spectrum Width at 20MHz and should select its consumer and small channel selected Output Power 20 dbm.
  2. Next set the default setting bullet Network Mode Network in Bridge mode, static IP address with IP address bullet loaded as follows:
    IP Address: 192.168.1.20
    Netmask: 255.255.255.0
    IP Gateway: 192.168.1.1
    Primary DNS IP: 202.134.0.155
    Secondary DNS IP: 202.134.0.62
  3. Then set the IP wifi laptop with IP bulletnya mate because the bullet is in bridge mode. Until this stage settings as Accsess Point bullet is finished and then do the ping, if the settings are correct reply.