Assemble Homebrew Antenna 2.4GHz "explained as follows,
Omni antenna has a radiation pattern that spreads out in all directions equally, so suitable for use as an antenna access point.
Diagram Antenna Omni Collinear 2.4GHz 
Diagram Sambungan Antenna Omni 2.4GHz ke Access Point
Omni antenna has a radiation pattern that spreads out in all directions equally, so suitable for use as an antenna access point.
Material
PVC pipe 1 inch in length is adjusted with the antenna element
Close the pipe 1 inch: 2 pieces
Email wire diameter: + / - 1 mm
N-type female connector
Pipe clamps: 2 pieces
Bolts to taste
Foam plastic taste
Making way
Prepare materials NECESSARY
Install N-Connector to cover 1 inch pipe That Will Be Displayed on the bottom.
PVC pipe 1 inch in length is adjusted with the antenna element
Close the pipe 1 inch: 2 pieces
Email wire diameter: + / - 1 mm
N-type female connector
Pipe clamps: 2 pieces
Bolts to taste
Foam plastic taste
Making way
Prepare materials NECESSARY
Install N-Connector to cover 1 inch pipe That Will Be Displayed on the bottom.
- Replace the plastic foam formed lingkarang which split in part to the support email for center wire in the pipe and not crooked.
- Enter your email wire have fitted plastic foam into the pipe.
- Solder wire to the inner end of the bottom of the email n-Connector.
Put the two close the pipe.
- Prepare the clamps as shown below. Using any insulating material that is strong enough and durable when installed in outdoor. White plate on the picture below is made of ½ inch PVC pipe that is heated and then pressed. Arches that form the letter C is made of 1 inch PVC pipe that split roughly ¼ of the circle.
Attach clamps to the omni antenna.
- Connect the antenna to the antenna mast pipe as shown below
